[Download] Sprint S6 and Sprint S6 edge 5.1.1 Stock Firmware now available

The Sprint Galaxy S6 and S6 edge Android 5.1.1 OTA update which began rolling out last week are now available for download as full Odin flashable firmware.

The firmware comes with same build number as the OTA update — G920PVPU2BOF7 for the normal S6 variant and G925PVPU2BOF7 for S6 edge variant. You can grab the full stock firmware for both the devices from the download links below, and if you need help with flashing the firmware using Odin, there’s a handy guide as well at the links below:

[icon name=”download” class=”” unprefixed_class=””] Download Sprint S6 G920PVPU2BOF7 full firmware [icon name=”download” class=”” unprefixed_class=””] Download Sprint S6 edge G925PVPU2BOF7 full firmware [icon name=”download” class=”” unprefixed_class=””] Download Odin 3.10.6

How to Install a Firmware Using Odin

1. Unzip the Odin 3.10.6 .zip file and run/open Odin3 v3.10.6.exe file from the extracted files on your PC.
2. Boot your Sprint S6 into Download mode:
   1. Switch off your phone.
   2. Press and hold “Home + Power + Volume down” buttons for a few seconds until you see a warning screen.
   3. Press Volume Up on the warning screen to accept it and boot into Download mode.
3. Once your S6 is in download mode, connect it to the PC with a USB cable. The Odin window on PC should detect the phone and show an “Added!!” message.
4. Now extract .zip firmware file you downloaded above to get the Odin flashable .tar file inside.
5. Now click on the PA tab on Odin window and select the .tar.md5 FIRMWARE that you downloaded above.
   └ Note: DON’T play with any other options on the screen. You’re only required to connect your Galaxy S6 and select the FIRMWARE file in PA tab.
6. Click the Start button on Odin and wait for it to finish the process. Once it has finished successfully, you’ll see a pass message on the Odin screen.
7. Your phone will automatically reboot when Odin is done flashing. You can then disconnect your Galaxy S6.

Cheers!