Kindle Fire Stock ROM Installation Guide
Looking for a way to get back to stock ROM on your Kindle Fire, after you flashed a custom ROM that didn’t worked great.
Well, here is a way ─ developer JackpotClavin, who has been developing CM7 for Kindle Fire, has come up with a solution to flash the original firmware back to your Kindle Fire.
- ADB must be working with your Kindle Fire, and you must know how to work with ADB
- You must have the stock recovery installed
- Full charged battery
- A USB cable
1. Download the original firmware: Download the latest stock firmware for your KF from the Amazon site → link here.
You may only find the latest firmware at the Amazon site, so if you’re looking for specific version, have look at the list below:
Right now I only have the firmware version 6.2 (which is actually latest, for now) but starting from today, I’ll post every new firmware here:
- Firmware version: 6.2_D01E_3003020
Download link → here.
2. Download command file: Download the command file → link here.
How to the Flash back to Stock ROM on your Kindle Fire:
The methods and procedures discussed here are considered risky and you should not attempt anything if you don’t know completely what it is. If any damage occurs to you or your device, we won’t be held liable — you only will be responsible, you’ve been warned!!!
Here’s the step by step guide to flash back to stock firmware on your Kindle Fire (KF).
- Connect with PC: Connect your KF to your PC with a USB Cable, and turn on USB Mass Storage mode from notification bar (if it doesn’t mount automatically)
- Transfer the firmware file: Transfer the firmware that you downloaded for your KF as per the instructions below:
- Rename the firmware file to “update.zip”, yes even if it’s “.bin” you just rename it to “update.zip”, and make sure it’s “update.zip” NOT “update.zip.bin”.Okay.
- Transfer the “update.zip” file to your KF inside the “kindleupdates” folder, if there’s no folder with that name, then create one, and transfer the file to it.
- Transfer the command file: Transfer the command file (downloaded above) to the root of your SD Card (not inside any other folder). And make sure it’s named only “command” NOT “command.txt“.
- Turn off USB Mass Storage mode: After you’ve transferred the files, turn off the USB Mass Storage mode by tapping on the disconnect button.
- Open command prompt: Now comes the role of ADB, and as mentioned above you must have the knowledge of working with ADB.
So open command prompt and type the following commands:
cp /sdcard/command /cache/recovery/
idme bootmode 0x5001
- Your KF will now reboot, and the stock firmware should be installed.
If you want to say thanks to JackpotClavin and buy him a beer, you can do so here → Paypal link.
And to thank us for this neat guide, you may use the comments box below :)